Premier SOL-5040 Manual De Instrucciones página 11

LED lamp are ling enough ,so please do not lengthen them or change them at random. But if you have
to change them or change them at random. But if you have to change them. Please make sure the area
of the cable connection solar panel is not less than 0.5MM²,while for LED lamp, not less than 0.3mm
².All the connection cables have negative and positive part, please distinguish them.
Attention:
2. The system charges for the battery only when the switch is on.
2. When the unit is in charge mode, the LED is on, when it is charged full, the red LED flickers.
3.Breakdown and disposal
3.1 Solar panel indicator off: Please check whether the solar panel is facing the sun; whether the
machine switch is on; whether the battery is in full capacity state; whether the connecting of the solar
panel is short-circuit or reversed.
3.2 No load output and the load indicator off: Please check whether the batter is in low voltage, whether
the voltmeter showing is less than 10V and if it so, please charge the battery for 10 continuous hours
and then use it.
3.3 No load output, load indicator on: please check whether there is bad connection of the load, then
connect again. Check whether the load is overloaded, short-circuit, and disconnect the load for 1 minute
the connect again.
4.Maintenance
4.1 This system should be used indoor. Please do not expose do not expose the machine onto sunshine
and wet places .If there is water inside by accident, please turn off the switch and dry the water inside
and then you can use it.
4.2 If you are going not to use this machine for long, please turn off the power switch and charge the
battery every month (battery voltage higher than 14V)
4.3 Please do not make the battery in the state of low voltage. Otherwise it will shorten the using time of
the battery. After on time of low voltage, please charge over 2days and then it.
P-4