Idiomas disponibles
Idiomas disponibles
USE AND OPERATION
Before first Use
• Remove the exterior and interior packing
• Before connecting the appliance to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the
cooling system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• Place your appliance on a floor that is strong enough to support the appliance
when it is fully loaded. To level your appliance, adjust the front legs at the bottom of
the appliance.
• Foe recedes installation away from direct sunlight and sources of heat (stove,
heater, radiator, etc.).Direct sunlight may affect the acrylic coating and heat sources
may increase electrical consumption. Extreme cold or hot ambient temperatures
may also cause the appliances not to perform properly.
• Not designed for placement in adage or basement.
• The appliance is for indoor use only.
Operation
It is recommended that you installed the wine refrigerator in a place where the
ambient temperature is between 10-25 .If the ambient temperature is above or
below recommended temperatures, the performance of the unit may be affected. The
temperature may fluctuate depending on whether or not the interior light is on or off or
whether the bottles are located on the upper, middle or lower section.
How to set temperature
There are three touch-buttons on the control panel:
• Use the arrow buttons to increase or decrease the set temperature by 1°C .
• Use the light button to turn on or off the interior light.
Notes on cooling
• This product is designed for max imum cooling of 14°C below ambient temperature.
• When the ambient temperature around 25°C or less, unit can maintain a
temperature range between 1 1-18°C.
EN
15
