Makita DTW450 Manual De Instrucciones página 7

NOTE:
• Use a dry cloth to wipe the dirt off the lens of
lamp. Be careful not to scratch the lens of lamp,
or it may lower the illumination.
• The light is provided with anti excessive dis-
charge circuit. When the lamp does not light up
even after the light switch is turned on, there is
likely to be battery power drop. Try to charge the
battery cartridge.
• Keep the lamp switch in "off" position while not
in need of the light.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Selecting correct socket
Always use the correct size socket for bolts and nuts.
An incorrect size socket will result in inaccurate and
inconsistent fastening torque and/or damage to the bolt
or nut.
Installing or removing socket
For tool with light fit detent pin
1
3
4
► 1 . Socket 2. Hole 3. Anvil 4. Detent pin
Align the hole in the side of the socket with the detent
pin on the anvil and push it onto the anvil of the tool until
it locks into place. Tap it lightly if required.
To remove the socket, simply pull it off.
2
For tool with firm fit detent pin
2
4
► 1 . Socket 2. Anvil 3. Hole 4. Detent pin
To install the socket, align the hole in the side of the
socket with the detent pin on the anvil.
Push the socket onto the anvil until it snaps into place.
Tap it lightly if required.
To remove the socket, depress the detent pin through
the hole in the socket and pull the socket off the anvil.
Hook
CAUTION:
that it is screwed firmly.
3
4
► 1 . Groove 2. Screw 3. Hook
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
7 ENGLISH
1
2
After installing the hook, make sure
1
3
3
4
2