Idiomas disponibles
Idiomas disponibles
EN
RESTORATION
OF
OPERATIONS
• Now lift the handle 10 until it locks.
• Stop the pump connected to the filter by
removing the power supply.
• With the handle 10 raised, turn the
selector 11 «FILTER/CLEAN» in line
with the «FILTER» marking.
• Lower the handle 10 until it locks.
• Press the flow switch 20 with the palm of
your hand and turn it counter- clockwise
until it stops. Now release it.
• Remove coupling 13 from the exhaust
pipe and close it with cap 12.
• Reactivate the pump by reconnecting it
to the power supply.
FILTER MAINTENANCE - CLEANING
AND REPLACING SPONGES AND
FILTER MEDIA
CAUTION: Always disconnect the pump
from the mains before carrying out any
maintenance.
• Once the pump has been disconnected
from the mains, it is advisable to remove
the water inlet and outlet pipes in order
to work without any obstruction.
• Never open the metal ring 16 before
disconnecting the pump.
• Open the metal sealing ring 16.
• Remove the filter cover, paying attention
to the seal. This should be washed and
possibly greased (silicone grease only)
for future use.
• Remove the sponges and fibre and
FILTERING
wash them under running water or
replace them.
• Remove the grid at the bottom of the
filter and wash the area underneath
thoroughly under running water.
• Reassemble the filter by following the
steps described above in reverse order.
• Check that seal 17 of the cover is
correctly positioned.
6.
WINTERIZATION
For correct and efficient operation, the
pump requires simple but necessary
periodic maintenance. First, remove the
plug from the socket and proceed as
follows:
1. Release the locking ring on the scroll
by pulling the tab outwards.
2. Remove the ring.
3. Remove the pump housing by rotating
it and pulling it forward at the same time
(in case of clogging, this may require a
certain strength).
4. Remove the complete rotor with the
flange.
5. Rinse under running water, using a
toothbrush to remove any encrustations.
6. Reassemble in reverse order, ensuring
the seal is in the correct position and
insert the volute, wetting the seal to
facilitate insertion.
7. Replace the ring with the larger teeth
facing the pump and close it by pressing
the tab until you hear a «click». Any
MAINTENANCE
AND
