Idiomas disponibles
Idiomas disponibles
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin / bidet.
3. Slip the slide washer, washer and collar nut over
the threaded base and tighten the collar nut by
hand.
4. Tighten screws.
5. Connect the supply pipes to the angle valves;
cold right - hot left.
6. Connect the pull rod to the pop-up waste.
Large differences in pressure between the hot and
cold water supply should be balanced.
Technical Data
This mixer series-produced with
waterdimmer (flow limiter)
Rate of flow with waterdimmer:
Rate of flow without waterdimmer:
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Hansgrohe single hole mixers can be used together
with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
If the continuous flow heater makes any problems or
there comes not enough water, the waterdimmer
(flow limiter 8a) located behind the mousseur must
be removed.
To simplify installation pressure hoses no.
13098000 are available.
English
Spare parts
1
2
3
4
5
6
7
8
9
10 pull rod cpl.
11 fixation cpl.
XXX = Colors Mondaro
000 chrome plated
7 l/min 3 bars
010 chrome/gold/jewel
14 l/min 3 bars
090 chrome/gold plated
max. 10 bars
490 white/gold plated
1 - 5 bars
840 fine brass
16 bars
max. 80° C
XXX = Colors Uno
65° C
030 chrome/blue
060 chrome/black
330 blue
430 red
450 white
480 yellow
610 black
knob for cold water Mondaro
knob for hot water Mondaro
knob for cold water Uno
knob for hot water Uno
spout for sink Mondaro
spout for sink Uno
spout for bidet Mondaro
spout for bidet Uno
washer
aerator cpl. (10)
aerator gold plated
ELASTOP stop unit
18291XXX
18292XXX
13291XXX
13292XXX
95030XXX
92030XXX
95230XXX
92230XXX
92646000
13085000
94980990
94149000
92620XXX
13961000
