Idiomas disponibles
Idiomas disponibles
3. Remove key from keyway.
Installation of a new clutch
1. Clean shaft and remove any burrs.
2. Apply anti-seize compound to the shaft.
3. Place key in keyway on shaft.
4. Slide clutch onto shaft, secure with bolt, flat washer and lock washer.
5. Tighten two allen head set screws.
Troubleshooting
Depending on the symptoms that you notice, you can discover the probable cause and
solve the problem.
Symptom
The machine does not
work properly
The rotor does not suction
the wood
The shredded material
does not have the same
thickness
The engine does not start
or it stops by itself
The machine gets stuck
during use.
The engine does not start
because of the rotor is
stuck
Problem
The blades are blunt
The diameter of the
branches is too big
The space between the
blades is not correct
Engine electric problem
No petrol left
There is no engine oil or is
low
The diameter of the
branch is too large
Impeller or blades have
woody residue or chunks
stuck to them
Correction
Sharpen or replace the
blades
Remove the branches with
a diameter wider than
that permitted.
Adjust the space to 1 mm.
Avoid the accidental start
up of the machine. Verify
that the switch is in the
ON ¨I¨ position. Make sure
that the SC System is set
to ON.
Add fuel
Add oi
Turn off the engine and
remove the spark plug.
Remove the cap of the
rotor shaft. Turn the rotor
a few degrees with a
wrench specially designed
for this purpose.
Leave the rotor blocked
using the key. Remove the
material from the inlet
tube with the help of a
stick or a tool and restart
