Idiomas disponibles
Idiomas disponibles
Replacement of the anvil
The Anvil is also reversible. When the edge of the Anvil is worn, it can be rotated.
When both edges are worn, the Anvil must be replaced.
The space between the blade and the anvil should always be 1mm.
Blade sharpening
• You should never attempt to sharpen the chipper blade.
• It is extremely important that the 45-degree angle be maintained consistently for
proper performance.
• The chipper blade should be taken to a machine shop for proper sharpening.
• Excessive heat generated during the sharpening process will damage blades and
weaken the metal.
Adjusting or replacing belt
Belt adjustment
The belt on your chipper should deflect 9mm (3/8") under three pounds of pressure
as shown below. If it doesn't, adjust per the following directions.
