Technical Specification - DPlus Automation Systems Hoop SPOT7 Instrucciones

EN ALARM INSTRUCTION
1. Short-circuit the final public terminal to activate the alarm, and the indoor monitor will ring.
During this period, press the call button to stop the alarm and enter the standby mode.
2. When in recording mode, 120s continuously display and record the image. During this period,
press call button to stop alarm and enter standby mode.
3. When in snapshot mode, a photo will be taken at the beginning of alarm, and the image is
continuously displayed within 120s. During this period, press call button to stop the alarm
and enter standby mode.
ALARM SENSOR WIRING DIAGRAM
1.Suitable for connecting two normally closed (NC) or normally open (NO) alarm inputs.
Two alarm input channels without input limitation ( can be normally open or normally closed).
2. The ALM terminal of alarm sensor is connected to ALM terminal of indoor monitor (the
alarm sensor is powered by external power supply).
3. Alarm sensor GND terminal is connected to camera GND.
4. For NO alarm input, when GND and ALM are connected, the alarm will be triggered.
5. For NC alarm input, when GND and ALM are off, the alarm will be triggered.
6. Suitable for any alarm sensor.
EN

TECHNICAL SPECIFICATION