Whirlpool ADN 248FS Manual De Instrucciones página 8

Take two supports from the bag and insert them into the guides at the top back part of
•
the appliance (see fig. 4, page 1).
The appliance should not be connected to the mains until all packing and
transport materials aren't removed. Suitably dispose the packaging material.
Once the unit has been positioned, wait for about 30 minutes before it is connected to
•
the mains.
If the device has been tilted more than 30° during transport, allow it to
stand in an upright position for at least 4 hours before it is connected to
the mains. If this is not done, the appliance compressor may fail.
When first starting-up or after a period out of use, before putting the products in the
•
compartment let the appliance run at least 2 hours.
DESCRIPTION OF THE APPLIANCE, BASIC PARTS
See fig. 1, page 1
1 Thermostat knob
2 Power supply indication
1 ― THERMOSTAT KNOB. The temperature in the appliance is controlled using the
thermostat knob by turning it to one side or the other.
regulation".
2 ― ELECTRICITY SUPPLY INDICATOR.
electricity supply, the green indicator light is illuminated. Simultaneously also the the
temperature rise indicator lights up. It indicates that the freezer was switched off
for a longer time, i.e. the freezer is switched on for the first time, after defrosting or
after losing of voltage. When the temperature in the compartment again falls below
-9 ºC, the temperature rise indicator light will go out.
3 ― THE TEMPERATURE RISE INDICATOR. When the temperature in the freezer rises
above -9 ºC, the red indicator light is illuminated.
The freezer was switched off for a longer time, i.e. the freezer is switched on for the
•
first time, after defrosting or after losing of voltage.
The door of the freezer is opened o
•
r is being opened too frequently.
•
It is loaded a large amount of unfrozen foodstuffs.
•
The freezing system is failed, i.e. the indicator does not go out longer 6
•
hours and it is heard running compressor or the compressor does not
switch off. In this case you should apply to your service agent (at first
make sure that three above items were taken into account).
NOTE. The technical data of the appliance can be found on the rating label attached to
the inside wall of the appliance. For more information about the appliance, scan the QR
code on the enclosed energy label and / or visit the official website of the product
database: https://eprel.ec.europa.eu
Temperature rise indicator
3
(Red color)
4 Shelves (evaporators)
When the appliance is connected to the
It indicates that:
7
More in "Temperature