Idiomas disponibles
Idiomas disponibles
Before you start, please note the following:
∙ Always ensure that the correct number of washers is used on all hinge bolts and screws.
∙ So that the doors can close tightly against the frame, take the utmost care that they are
properly aligned during reassembly.
1.
Remove covers c from the inside of the housing and door and the upper bracket 6
together with the nut and washers and the gasket under the bracket.
2.
Remove the freezer door 1. Remove the stop plate from the bottom 2. Screw the stop
plate (included in the package) on the opposite side of the door to open the door to
the left.
3.
Remove the bottom cover 3 together with the small cover 4.
4.
Unscrew the shaft 5 together with the washers on the shaft and the catch 8 from the
lower bracket 6 and screw them to the bracket 7 on the other side of the cabinet
symmetrically to the former position.
5.
Push the freezer door onto the bracket 7 on the newly installed shaft 5.
6.
Remove the screw caps a and the blinds b. Unscrew the 9 fixing screws of the handle
and screw the handle on the opposite side of the door. Press the blinds into the
remaining holes in the door and place the covers on the screws.
7.
Rotate the bracket 6 together with the washers on the shaft and the plastic gasket at
an angle of 180 °. Unscrew the shaft together with the washers and screw in on the
opposite side of the bracket. After inserting the axis 6 of the bracket into the door of
the refrigerator compartment, screw it on the opposite side of the refrigerator in the
lower holes. Cover c with the bracket and the remaining empty cavity.
8.
Insert the cover 4 into the guides on the opposite side of the bottom cover 3. Replace
the bottom cover 3 in its original position.
Wait for about 30 minutes before it is connected to the mains. If the appliance has
been tilted to more than 30°, wait for about 4 hours before re-connecting it to
the mains.
OPERATION PROBLEMS AND THEIR SOLUTIONS
The appliance is plugged in to the mains but it does not work and the
•
electricity supply voltage indicator is not illuminated.
electricity supply installations are in order. Check that the plug is correctly inserted into
the electricity supply socket.
The noise has become louder. Check that the appliance is standing stable on a level
•
place. To make it level, regulate the front feet. Check if the appliance is not touching any
furniture and that no part of the refrigeration system at the back part of the appliance
body is touching the wall. Pull the appliance away from any furniture or walls. Check
that the cause of increased noise isn't due to bottles, cans or dishes in the appliance that
might be touching each other.
When the appliance door is opened, the rubber sealing gasket pulls out. The
•
gasket is smeared with sticky foodstuffs (fat, syrup). Clean the sealing gasket and the
groove for it with warm water containing soap or dishwashing detergent and wipe dry.
Put the rubber sealing gasket back into the place.
The temperature rise indicator light is illuminated red. This means the appliance
•
is being connected to the electricity supply for the first time or it was disconnected for a
significant period (for thawing or during an interruption to the electricity supply), the
freezer door is not closed or is being frequently opened and closed, or a large amount of
10
Check that your house
