KENMORE ELITE D10043MSLRIIH-WP Manual De Uso Y Cuidado página 11

Idiomas disponibles

Idiomas disponibles

OPERATION
CLOCK SETTING
When the microwave oven is plugged into an outlet, "00:00" will display.
(1) Press Timer/Clock, "Hr12" and "CLOCK" will appear in the display.
(2) Press the number pads and enter the current clock time. For example, if the time is now 8:30,
press "8, 3, 0" in order and "8:30" and "CLOCK" will display.
(3) Press Timer/Clock to finish clock setting, ":" will flash and the numbers will appear as a clock
time in the display.
Note: (1) In the process of setting clock, if the
within 25 seconds, the display will automatically return to standby mode.
(2) This is a 12 hour clock. If the numbers entered are not within the range between 1:00
to 12:59, the setting will not be accepted until valid numbers are entered.
TIMER
(1) Press the Timer/Clock twice, "00:00" and "TIMER" will display.
(2) Press the number pads to enter the time amount. The maximum amount of time that can be
entered is 99 minutes 99 seconds.
(3) Press
to confirm setting.
(4) When the time amount elapses, you will hear a long beep.
Note: 1) The Timer setting is different from the Clock setting; it is simply a timer.
2) The Timer function can be used in any cooking process.
3) You can check the timer during the timing process for 5 seconds by pressing
Timer/Clock once. You can cancel the timing process by pressing
seconds the timer is displayed.
MICROWAVE COOK
(1) Press Micro, "00:00" and "MICRO" will appear in the display.
(2) Press number pads to enter the cooking time; the maximum cooking time is 99 minutes and 99
seconds.
(3) Press Power Level ; PL10 and MICRO will display. This is the default power of 100%. Press
number pads 0 through 9 to select a different power level if desired. See the Power Level
table below.
(4) Press
to start cooking, system starts to count down.
Example: To cook the food with 50% microwave power for 15 minutes.
a. Press Micro , "00:00" and "MICRO"display.
b. Press "1, 5, 0, 0" in order for 15:00 to appear in the display.
pad is pressed or if there is no operation
EN-9
during the 5
loading