Hkoenig ICEK12 Manual De Utilización página 8

Idiomas disponibles

mechanical devices or other means to accelerate the

defrosting process, other than those recommended by

the manufacturer.

3. Reuse the machine after being idled for a period of time,

it may not have enough water to pump for air retard, and

the indicator of "ADD WATER" will keep lighting. At this

time, you just need to press POWER button again, the

machine can enter normal state.

4. To ensure the cleanness of ice, please change water for

water reservoir at least once one day. If do not use for a

long time, please drain the water out and clean it up.

5. If the compressor takes a strike action for shortage water,

fully water or interruption of power supply, it will delay for

3mins to start up after restarted.

6. Always use fresh water before starting ice production

either at initial installation or after a long shut-off period.

TROUBLESHOOTING ：

Please note, if a power failure occurs due to disconnection of the power cord, or the power button

has been pushed off during an ice making cycle, small ice chips may formed and lodge in the

automatic shovel causing it to jam. If this occurs, the ice chips may be removed by disconnecting

the power cord and gently pushing the shovel to the rear of the cabinet and removing the ice chips,

then restarting.

Please check if the water reservoir is flat when the ice shovel can not remove the ice to ice basket.

If not, please push the ice shovel gently by finger, then press POWER button to restart.

PROBLEM

The compressor works

abnormally

with

Buzzing

Noise

POSSIBLE CAUSE

The voltage is lower than

recommended