Comunello Automation FORT 400 ONE Instrucciones De Uso página 16

CONTENTS
1 GENERAL PRESCRIPTIONS
1.1 Safety prescriptions
1.2 Installation prescriptions
1.3 Operating prescriptions
2 MODELS AND PRODUCTS DESCRIPTION
2.1 Description
2.2 Typical installation
3 PRODUCT TECHNICAL SPECIFICATIONS
4 INSTALLATION
4.1 Preliminary checks
4.2 Operating limits
4.3 Preparatory work for installation
4.4 Installing the FORT operator
4.4.1 Installation
4.4.2 Installation of limit stops and switches
4.4.3 Operator manual release
5 PREPARATION FOR ELECTRICAL CONNECTIONS
6 TESTING
7 PRODUCT MAINTENANCE
8 SPARE PARTS
9 DISPOSAL OF THE PRODUCT
10 WARRANTY
1 PRESCRIPTIONS
1.1 SAFETY PRESCRIPTIONS
This installation manual is addressed exclusively
to professionally skilled personnel. Read all the
instructions carefully before starting the installation
procedures. Any operations that are not expressly
set down in these instructions are to be considered
prohibited; improper use may result in damage to
the product and place persons and property at
risk. The manufacturer declines all liability for failure
to observe best practices in gate construction and
for any possible deformation that may occur during
use of the product. Store this manual in a safe place
for future reference. The design and construction
of the devices of which model FORT is composed
and this manual are in full compliance with
statutory legislation.In consideration of potential
hazards that may arise during the installation and
use of FORT, the installation procedures must be
carried out in full compliance with the applicable
laws, standards and
1.2 INSTALLATION PRESCRIPTIONS
• Before starting the installation procedures
make sure you have any additional devices
and materials that may be required to
complete the automation system with FORT
in consideration of the specific application.
• The automation system must not be used until
the gate has been made safe
• Dispose of packaging
compliance with
16
COMUNELLO ®Copyright 2017 - All rights reserved
regulations; namely:
materials in
local regulations.
1.3 OPERATING PRESCRIPTIONS
• No modifications can be made to any part of
the product unless specified in this manual.
Unauthorized modification of the product is likely
to lead to malfunctions.
declines all liability for damage caused by
unauthorized modifications.
• The parts of the automation system must never
be immersed in water or other liquids. During
the installation procedures ensure that no liquids
penetrate inside the control unit or other open
devices.
• If liquids penetrate any parts of the automation
system disconnect the electrical power supply
immediately and consult the technical service;
the use of FORT in such conditions may give
rise to potentially hazardous situations.
• Keep all parts of FORT away from heat sources
and open flames; exposure to heat or flames
may damage the devices and cause faults, fire,
or hazardous situations.
• When the equipment remains unused for a long
time, remove the optional battery and store it
in a dry place to avoid the risk of leakage of
harmful substances.
• Connect the control unit exclusively to an
electrical power supply line equipped with an
efficient protective earth conductor.
• Any operations that require the housing of
FORT to be opened must be performed with
the control unit and the electrical power supply
disconnected; if the disconnect device is not
clearly visible from where you are working,
attach a warning notice to the effect:
"WARNING - MAINTENANCE IN PROGRESS".
• In the case of tripping of circuit breakers or blowing
of fuses, find the fault and remedy it before
resetting the circuit breaker or changing the fuse.
• If the fault cannot be remedied using the
information given in this manual, consult
technical service.
• The device can't be used by children younger
than 8 years of age and by people with reduced
physical, sensory or mental capabilities, or
without experience or the required knowledge
if not under surveillance or after having received
instructions about the safe use of the device
and the inherent risks in it. Children should not
play with the device. Cleaning and maintenance
should not be carried out by children without
surveillance.
The manufacturer