Idiomas disponibles
Idiomas disponibles
The type of bar and saw chain you use
is an important factor in the occurrence
and force of the kickback reaction. Some
STIHL bar and chain types are designed
to reduce kickback forces. STIHL
recommends the use of reduced
kickback bars and low kickback chains.
ANSI B 175.1-2000 chain saw kickback
standard
§ 5.11 of ANSI standard B 175.1-2000,
sets certain performance and design
criteria related to chain saw kickback.
To comply with § 5.11 of ANSI
B 175.1-2000:
a) Saws with a displacement of less
than 3.8 cubic inches (62 cm³)
must, in their original condition,
–
meet a 45° computer derived
kickback angle when equipped with
certain cutting attachments,
and must be equipped with at least
–
two devices to reduce the risk of
kickback injury, such as a chain
brake, low kickback chain, reduced
kickback bar, etc.
b) Saws with a displacement of
3.8 cubic inches (62 cm³) and
above
must be equipped with at least one
–
device designed to reduce the risk
of kickback injury, such as a chain
brake, low kickback chain, reduced
kickback bar, etc.
The computer derived angles for saws
below 3.8 cubic inches (62 cm³)
displacement are measured by applying
a computer program to test results from
a kickback test machine.
MS 150 C
WARNING
The computer derived angles of § 5.11
of ANSI B 175.1-2000 may bear no
relationship to actual kickback bar
rotation angles that may occur in real life
cutting situations.
In addition, features designed to reduce
kickback injuries may lose some of their
effectiveness when they are no longer in
their original condition, especially if they
have been improperly maintained.
Compliance with § 5.11 of ANSI
B 175.1-2000 does not automatically
mean that in a real life kickback the bar
and chain will rotate at most 45°.
WARNING
In order for powerheads below 3.8 cubic
inches (62 cm³) displacement to comply
with the computed kickback angle
requirements of § 5.11 of ANSI
B 175.1-2000 use only the following
cutting attachments:
bar and chain combinations listed
–
as complying in the "Specifications"
section of the instruction manual or
other replacement bar and chain
–
combinations marked in
accordance with the standard for
use on the powerhead or
replacement chain designated "low
–
kickback saw chain."
See the section on "Low kickback saw
chain and reduced kickback bars."
Devices for Reducing the Risk of
Kickback Injury
STIHL recommends the use of the
STIHL Quickstop chain brake on your
powerhead with green labeled reduced
kickback bars and low kickback chains.
STIHL Quickstop Chain Brake
STIHL has developed a chain stopping
system designed to reduce the risk of
injury in certain kickback situations. It is
called a Quickstop chain brake.
WARNING
To reduce the risk of injury, never use a
saw if the chain brake does not function
properly. Take the saw to your local
STIHL servicing dealer. Do not use the
saw until the problem has been rectified.
All STIHL chain saws are now equipped
with a Quickstop chain brake which can
be activated by inertia. If the forces of an
occurring kickback are sufficiently high,
English
13
