Idiomas disponibles
Idiomas disponibles
5 ASSEMBLY
5.1
8
Assembly
501610-01
501611-01
501612-01
501613-01
Preliminary work
–
Take off the passenger seat (see owner's manual).
–
Take off the front rider's seat (see owner's manual).
–
Remove the right side cover (see owner's manual).
Preassembly scope of supply
–
Position license plate lamp
(both included).
–
Mount and tighten nuts
–
Mount reflector bracket
(all included) and tighten.
–
3
Mount reflector
with clamping washers (all included) to
4
bracket
.
–
Position preassembled license plate holder
1
plate bracket
(included).
–
Route turn signal cable
(both included).
–
Mount splash protector
–
Route the wiring harness of the license plate lamp upward
without tension and secure with cable tie
–
Mount rubber grommet
both wiring harnesses.
–
Mount and tighten screws
Guideline
Screw, license plate
holder
Demounting and dismantling the original license plate holder
–
ck
Remove screw
.
–
cl
Remove screw
.
–
cm
Remove screw
.
–
cn
Remove screw
.
8
on license plate holder
9
(included).
4
5
with screws
and nuts
2
on license
bq
through splash protector
bt
bk
with bushings
(included).
bs
(included).
br
(included) and feed through
bl
(included).
M6x22
10 Nm (7.4 lbf ft)
2
6
bt
