Moulinex LM81G810 Manual De Instrucciones página 33

• Remove the Blade Unit + Locking Ring + Seal (F1 + F2 + F3 / O1 + O2
+O3) and clean them under running water. The blades are very sharp,
handle them with caution to avoid injury (Fig. 10).
• After cleaning, remember to correctly fit the seal (F3, O3) back onto the
blade unit (F1, O1) (Fig. 17). Please be careful to avoid any damage to
the seal by touching the blades.
Note: Incorrectly fitting the seal can result in ingredients leaking from
the base of the blender jug.
• Rinse the inside of the jug and the lid under running water.
• Take care when cleaning the blades in the blender jug and when you
empty the jug as they are sharp.
• Use a damp cloth to clean the motor unit (A). Dry it carefully.
• The detachable parts (lid, blade unit, locking ring,) can be cleaned with
a sponge and hot soapy water.
• The jug (F4, O4), blade unit without titanium coating (F1), locking ring
(F2, O2) can be cleaned in the dishwasher on the upper rack - use the
'ECO' or 'LOW SALT' program.
• Caution: The jug (F4, O4), blade unit without titanium coating (F1) and
locking ring (F2, O2) must be disassembled and placed separately in the
dishwasher. Please do not put the blades with titanium coating (O1) in
the dishwasher.
60
19
18
WHAT TO DO IF YOUR APPLIANCE DOES NOT WORK
PROBLEMS
The plug is not connected
Appliance does not work
The blender jug is not
positioned correctly on the
The appliance stopped
while in use
The product is not placed
on a flat, stable surface
Excessive vibrations
Volume of ingredients is
Volume of ingredients is
Leak from the lid
The lid is not correctly
The blender seal (F3 / O3)
Leak at the bottom of the
is not positioned correctly
blender jug
Pieces of food are too large
The blade does not turn or too hard. Liquid has been
easily blended that was too hot
and has distorted the seal
YOUR APPLIANCE STILL DOES NOT WORK?
Contact an approved service centre (see list in service booklet).
CAUSES SOLUTIONS
Connect the appliance to
a socket with the same
voltage as that on the rating
plate of the appliance.
Check that the blender jug
is positioned properly on the
motor unit as explained in
motor unit
the instructions.
Follow the instructions in section
USING YOUR BLENDER.
Overload The cooling time is
variable and can last up to
30 minutes
Place the appliance on
a flat surface.
Reduce the quantity of
too high ingredients processed.
Reduce the quantity of
too high ingredients processed.
Place the lid correctly on the
positioned blender jug.
Reposition the seal with the
correct side uppermost (Fig. 1)
and lock the assembled blade
unit (F1+F2+F3 / O1 + O2 +O3)
or is absent onto the blender jug correctly
(Fig. 2, Fig. 3 & Fig. 4 / Fig. 9, Fig.
10 & Fig. 11)
Replace the seal with a
new one. Reduce the size
or quantity of ingredients
processed. Add liquid.
EN
61