Removing and cleaning the blade block
• Turn off the appliance.
• Remove the hair residues from the head using the brush H (fig. 1).
• Lubricate the head with the special oil (Fig. 3).
• Turn on the appliance briefly to ensure an even distribution of the oil film.
For thorough cleaning the head must be unscrewed.
Maintenance, replacement and adjustment of the head
The head components can be sharp. Take particular care during the
whole procedure.
• Unscrew the screws of the head and remove the cutting comb and the blade
(Fig. 4)
• Clean all the parts from any remaining hair.
• Reassemble by inserting the blade into the plastic feeder.
• Apply the comb and put the two screws back in.
• Before tightening the screws, check that the blade is aligned laterally to the comb
(Fig. 5–b/c) and align the comb so that between the front edge of the comb and
the front edge of the blade there is an approximate distance of 0.5 mm (Fig. 5-a).
• Tighten the screws.
• Recheck alignment of the cutting comb again.
• Repeat this procedure if alignment is poor or unsafe.
• Before using the appliance, check that it is working properly.
Incorrect alignment of the blade and the cutting comb can cause
injury. Ensure proper adjustment.
Lubrication
It is recommended to lubricate the blade unit daily or after every use.
To ensure that the cutting blade remains sharp, the cutting head must be lubricated.
It is recommended to regularly apply two to three drops of lubricant I (fig. 1) directly
on the blade (fig. 3).
If after a long period of use, and despite constant cleaning and oiling,
the cutting performance decreases, the head must be replaced.
Failure to lubricate the appliance is considered as "FAILURE TO COMPLY WITH
THE INSTRUCTIONS FOR USE", therefore, the warranty will be automatically
rendered null and void.
DISPOSAL
The product packaging is made of recyclable materials. Separate the parts
according to their type and dispose of them in accordance with applicable
laws on the environmental protection.
Disposing of the battery and power adapter.
• Turn off the appliance.
• Remove the battery from its compartment.
8