Daikin FWF02D FWF03D FWF04D FWF05D Manual De Instalación Y Funcionamiento página 17

6 Cable clamps (c).
7
7 Configuration
7.1 Decorative panel setting
Make the following field settings so that they correspond with the
actual installation setup and with the needs of the user:
▪ Design decoration panel (if applicable)
▪ Air flow direction
INFORMATION
In case the flaps operate automatically:
When the fan starts to operate, the flaps open completely
and then remain in the set position. Check the below table
for appropriate angle settings.
When the fan stops to operate including thermo off, the
flaps open completely and then close completely.
NOTICE
Make sure that the dip switch setting is correct according
to panel type, otherwise panel will not work properly.
FWF02~05D
Fan coil units
3P443944-9T – 2023.01
Setting: Air flow direction and design panel
NOTICE
If the flaps are required to open and close automatically,
the decorative panel cable must be connected to the PCB.
Otherwise, the flaps must be adjusted manually. (Refer to
"5.5.2 Connecting the optional
NOTICE
The "Adaptor (EKRP1CAS5A)" is mandatory option for
PCB connection of the "Design Panel (BYFQ60C)"
NOTICE
Flap angle can only be adjusted by the dip switch on the
PCB.
The flap positions of the decorative panels can be adjusted using the
dip switch on the PCB. Please see the 4 different flap position
options in the table.
Panel type Option
a
Standard Fully open
(BYFQ60B)
35 ̊
Design -
(BYFQ60C)
c
2 1
1 G O N
2 1
1 G O N
a
a
35°
c
45°
7 Configuration
equipment" [ 4 12])
b c
- -
36 ̊ 45 ̊
2 1
2 1
1 G O N 1 G O N
b c
b
36°
d
53°
Installation and operation manual
d
-
Fully open
53 ̊
2 1
1 G O N
d
17