Makita DTM51 Manual De Instrucciones página 7

Adjusting the orbital stroke rate
1
014557
The orbital stroke rate is adjustable. To change the
orbital stroke rate, turn the dial between 1 and 6. The
higher the number is, the higher the orbital stroke rate is.
Preset the dial to the number suitable for your
workpiece.
NOTE:
The dial cannot be turned directly from 1 to 6 or
•
from 6 to 1. Forcing the dial may damage the tool.
When changing the dial direction, always turn the
dial moving it through each intermediate number.
Indication lamp
1
014558
When the remaining battery capacity gets low, the
•
indication lamp blinks.
When the remaining battery capacity gets much
•
lower, the tool stops during operation and the
indication lamp lights up about 10 seconds.
At this time, remove the battery cartridge from the tool
and charge it.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing application tool
(optional accessory)
WARNING:
Do not install application tool upside down.
•
Installing application tool upside down may
damage the tool and cause serious personal injury.
1. Dial
1. Indication lamp
7
Install attachment tool in the correct direction
•
according to your work. Application tool can be
installed at an angle of every 30 degree.
CAUTION:
Be careful when closing the lock lever. The lock
•
lever may close suddenly and pinch your finger.
Clean up dust and perform lubrication on the
•
moving part of the lock lever from time to time.
Otherwise dust may accumulate in the moving part
of the lock lever and hinder its smooth movement.
Do not start the tool while the lever opens. The
•
tool may be damaged.
1. Open the lock lever fully. And remove the holder
bolt.
2
014555
2. Put an application tool (optional accessory) on
the tool flange so that the protrusions of the tool
flange fit in the holes in the application tool.
3
014553
3. Insert the holder bolt till it stops. And then, return
the lock lever to its original position.
014564
When using sanding application tool, mount the
application tool on the sanding pad so that it matches
the sanding pad direction.
The sanding pad has a hook and loop type fitting
system which allows easy and rapid fitting of a sanding
paper.
1. Holder bolt
2. Lock lever
1
2
1. Holder bolt
2. Holes in the
application tool
1
3. Protrusions of
the tool flange
2
1