Idiomas disponibles
Idiomas disponibles
The additional handle must be screwed in at the left or
right in the gearbox head.
Befor fitting, blow out the thread in the gearbox head.
2.1.4 A
/
ttAching
detAching the grinding tOOl
Place the mounting flange on the spindle so that the lon-
gitudinal groove is at the bottom.
Put on the grinding tool. The projecting centring collar on
the mounting flange must engage precisely in the hole in
the grinding tool.
Lock the spindle in place with a single open ended span-
ner. Tighten the clamping nut with the face pin wrench.
Follow these instructions in reverse order to detach the
grinding tool.
Use only those tools recommended by SUHNER.
You must also observe the safety instructions issued by
the manufacturer of the attachment.
You must check that the tools diameter is within the limits
and the max speed is higher than the tool's idle or set
speed.
The tool shaft must fit precisely in the receiver.
The tool must be secured as deeply as possible in the
receiver. The larger the exposed shaft length and the
shorter the clamped length, the lower the max speed.
The installed attachment must be able to rotate freely. Af-
terwards a test run must be conducted without load for
at least thirty seconds. Vibrating tools must be replaced
immediately.
2.2 r
Ating dAtA
Connection
Maximum speed Input
Maximum speed Output
Gear i=
Max wheel diameter
Spindle thread
Vibration EN 60745
Weight
The specified vibration value was measured with a
standardised test method and may differ from the
actual operating value. The specified value can be
used for product comparisons or for an introductory as-
sessment of work breaks.
2.3 O
perAting cOnditiOns
Temperature range during operation: 0 to +50°C
Relative air humidity: 95% at +10°C not condensed
3. h
andling
3.1 w
Orking instructiOns
To achieve an optimum grinding result,
move grinding tool uniformly back and
forth with light pressure.
Excessive pressure lessens the working capability of the
hand tool, as well as the life of the grinding tool.
3.2 s
/
witching On
Off
Hold the hand tool firmly.
The drive generates a high starting torque. This
can lead to unpredictable movements of the hand
tool.
Switch on the drive.
Conduct the test run without load for at least thirty sec-
onds. Do not use vibrating grinding tools.
You must always hold the hand tool when it is operating.
Switch off the drive when you stop working. The tool still
needs time to stop after the machine has been switched
off.
Press the spindle lock only when it is not rotating!
Put down the hand tool so that there can be no danger.
Remove the hand tool from the shaft.
G22
-1
28'000min
-1
10400min
2.7:1
110mm
M14
2
2
6.2m/s
, K=1.5m/s
0.660kg
/o
Peration
21
