Team kalorik TKG TO 1020 Manual De Instrucciones página 8

Fax +32 2 359 95 50
CAUTION: the bread carriage handle will not stay down if the appliance is not plugged in!
BEFORE USING THE TOASTER FOR THE FIRST TIME
In order to eliminate any manufacturing residues, operate the toaster a couple of times without
bread with the browning control selector on a medium power level. Some smoke might
escape.
OPERATION
•
Before using your appliance for the first time, check if it is clean (see "Maintenance and
cleaning") as it comes into direct contact with bread. Check if any object has fallen into
the slot.
•
Connect the appliance only to a mains earthed wall socket.
•
Place the bread slices in the slot (for French bread, cut a loaf shorter than the slot, then
cut it in two pieces along its length). Your appliance is provided to receive French bread,
but also pieces of toast or other bread slices if their thickness and their length are shorter
than the one of the slot.
•
Press down the bread carriage handle until it stops (in the same time, the grid inside the
slot will tighten around the bread in order to keep it away from the heating wires). Then
release the pressure and the handle will stay in the lower position, which means that the
heating process has begun. If the handle comes up immediately, check if the appliance is
plugged in as it blocks only when the unit is plugged in.
•
You can adjust the browning intensity to obtain a more or less toasted bread by
positioning the browning control selector to one of the degrees marked from 1 to 7.
Therefore you only have to turn clockwise to increase the intensity, and anticlockwise to
decrease it. The higher the number is, the more toasted the bread will be.
•
During the functioning, if you think that the bread is toasted enough or for another reason,
you can break the heating process simply by pressing the cancel button (STOP).
•
The reheat button (
which is not toasted enough during a short time without modifying the browning degree.
•
The defrost button (
•
Always unplug the appliance after use and let it cool down before handling or storing it.
•
A cord winder is foreseen on the bottom of the appliance: hooks. When you store your
appliance, wind the cord around the hooks.
RACK FOR BUN WARMING
Your appliance is provided with a rack for bun warming. To install the rack, insert its feet in the
openings foreseen to that purpose inside the slot of the appliance. To store the rack, proceed
inversely.
CAUTION: before using the rack for bun warming, fold out its feet as indicated on picture „B".
MAINTENANCE AND CLEANING
•
Before attempting any cleaning operation, make sure the toaster is unplugged from the
supply socket and fully cooled down.
•
To remove bread crumbs, slide the crumb tray situated on the side of the appliance.
•
Caution! It is very important to empty the crumb tray regularly. Crumbs that have
accumulated in the toaster might burn and the appliance might catch fire.
•
Never use sharp objects to clean the toaster. Doing so could damage the appliance.
•
To clean the exterior surfaces, simply wipe over with a soft damp cloth.
•
ON NO ACCOUNT MUST THE TOASTER BE IMMERSED IN WATER OR ANY OTHER LIQUID.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
) allows you to reheat already toasted bread or to toast bread
) allows you to toast bread that has been frozen beforehand.
8
Assembly page 8/36
TKG TO 1020 - 130124