Idiomas disponibles
Idiomas disponibles
28/29
09. Start up
BEFORE CARRYING OUT ANY OPERATION, RELEASE THE PRESSURE
ACCORDING TO THE INSTRUCTIONS PROVIDED IN PARAGRAPH 9.1
- Connect the pressure pot to the
compressor.
Turn
the
wheels (1) anticlockwise. Close the
product outlet valves (2).
- Once the equipment has been assembled, check that the hose is connected correctly.
- Before operating the pressure pot, check that it
completely depressurised (the pressure gauge show 0)
- Disconnect the air hose from the pressure regulator.
Lift the lid and fill the pressure pot.
- Prepare the paint according to the instructions
provided by the manufacturer. Filter the paint to
eliminate the bigger particles that might clog the gun or
obstruct the fluid passages.
- Tank filling; never exceede the máximum filling ¾
level.
- Close the cover. Once the pressure pot lid has been
closed securely, open the product outlet valve and
connect the air hose to the pressure pot again.
Turn the pressure regulator (1), checking that the
product comes out of the gun through the hose.
09.1. Pressure release procedure
The tank remains under pressure until the pressure is released manually.
Follow the instructions to release pressure from pressure tank:
- BEFORE INSPECTING OR OPERATING THE SYSTEM
- AT THE END OF JOB OPERATIONS
1. Interrupt the air supply by closing the air inlet ball valve.
2. Disconnect the air inlet hose.
3. Open the discharge valve.
4. Wait until no more air passes through the discharge valve.
5. Unscrew the clamps and remove the lid.
6. Leave the discharge valve open, until the lid is put back in place.
regulator
ENGLISH
1
mín.
10 cm.
2
