Idiomas disponibles
Idiomas disponibles
(Original instructions)
A - Heater bars
B - Lateral supports
C - Temperature/Timer indicator
D - Timer
E - On/off button
F - Shelf
G - Wall brackets
G-1 - Trim
G-2 - Screws
G-3 - Front accessories
G-4 - Internal accessories
G-5 - External accessories
H - Fixing screws
I - Wall plugs
J - Wall screws
K - Trim
L - Support brackets
If the accessories described above are not
available for your model of appliance, they
can also be purchased separately from
Technical Assistance Services.
-
Do not use the device if the accessories
or consumables attached to it are
defective. Replace them immediately.
-
Do not use the device if its on/off button
does not work.
-
Keep this appliance out of the reach of
children and/or persons with reduced
physical, sensory or mental capabilities
or lack of experience and knowledge.
-
Do not use the appliance for purposes
other than heating and drying towels or
heating the room.
-
Do not place the appliance too close to
showers, bathtubs, swimming pools, etc.
-
Do not immerse the appliance in water
or any other liquid.
-
Do not use the appliance on the floor.
-
It is normal to hear some noises when
the appliance is heating or cooling.
-
CAUTION: This appliance is intended
only for drying textiles soaked in water.
-
CAUTION: Some parts of the appliance
can become very hot, so be careful not
to touch it until it has cooled down.
Before mounting the unit, make sure that
it meets the following requirements:
-
The control panel must be at the bottom.
-
The distance between the bathtub or
shower and the appliance must be at
least 60cm.
-
The distance between the ceiling and the
appliance must be at least 25cm.
-
The distance between the floor and the
appliance must be at least 80cm.
Shelf attachment:
-
Remember that, to fix the shelf, the
appliance must not be attached to the
wall.
-
You will need to fix the shelf horizontally
between two heating rods (A), whichever
you wish.
-
Place the shelf (F) in position and from
the back of the appliance, using the
accessory (L) and the screw fix one side
without screwing it all the way in.
-
Now repeat with the other side and when
the shelf is secured, finish screwing both
screws.
-
Place the two trims (K) so that the
screws are not visible.
Wall mounting (Fig.1, 2 and 3):
-
Mark 4 points on the wall, where the
holes should be drilled. The horizontal
distance between the points should be
41cm and the vertical distance 22cm.
-
Once marked, drill the four 8mm
diameter holes.
-
Separate the different parts of the wall
brackets as shown in the picture of the
device parts.
-
Insert the wall plug (I) into the hole in the
wall and then insert the external
