COSY ARTEVINO Modo De Empleo página 31

IV. Humidity display (single-temperature model)
Your wine cabinet has a function to measure humidity, allowing you
to see the relative humidity level inside the appliance. The ideal
humidity level is above 50%, ideally 60 - 75%.
To display the humidity level inside your cabinet, press and hold
down the button for 2 seconds
V. Lighting mode
1
Press the key.
The indicator light of the active mode will flash.
You have 2 setting options for lighting:
Permanent lighting (for mood lighting).
Lighting disabled.
8- Everyday maintenance of your wine cabinet
Your ArteVino wine cabinet is a tried and tested appliance.
Maintenance procedures to carry out every 3 months
Clean the ventilation filter:
• Remove the 2 screws from the grill
(supplied in the accessories bag).
• Remove the grill, retrieve the filter and place it under water
• Allow it to dry then reassemble everything.
Maintenance procedures to carry out once a year
• Unplug and unload the appliance. • Remove any particles that could block the drainage pipe located inside the cabinet, at
the bottom.
• Clean inside the compartments with water and a gentle cleaning product.
• Rinse thoroughly. Dry with a soft cloth.
• Check the condition of the door seal. Cleaning the seal often proves necessary. Cleaning with unsuitable products will cause premature ageing
of the seals. You should therefore follow these rules: Whenever cleaning the seal, finish by rinsing the seal with clean water. There must be no
cleaning product remaining on the seal. Artevino recommends that you use only a mild soapy solution. If cleaning with this type of solution
proves insufficient, it is possible to use, on a one-off basis, an Ethanol-based solution, but with a concentration of less than 10%, and ensuring
that you rinse the seal with clean water.
If you want to increase the relative humidity level in your cabinet,
pour the equivalent of one glass of water onto the humidity cartridge
positioned on the rack at the base of the cabinet, having first
removed the bottles.
2 sec.
2 secs
2
3
1
using a n° 2 Allen wrench
2
.
Press the or keys to select the desired mode.
Press the key to confirm.
Precautions to observe: bright light,
never look directly into the beam.
2
1
EN
14