Idiomas disponibles
Idiomas disponibles
1. There are two slots along the length of the lightstick that can be used for mounting.
Depending upon your application, slide the two enclosed #10 carriage bolts into the
appropriate slot (rear or bottom).
2. Slide them along the channel to the desired location and mark the locations for your mounting
holes on the mounting surface.
3. Drill your holes and mount the light using the enclosed washers and nuts.
Use standard On/Off switches rated for 5 amps and make your connections according to the appropriate wiring diagram below.
Wiring for 8- or 6-Head Units
Please Note: The RED wire must be connected to +12VDC
for any of the functions to work.
RED - Power
ORANGE w/RED - Warn
WHITE w/BROWN - Left Arrow
GREEN w/YELLOW - Right Arrow
GREEN w/RED - Pattern or Phase Select
(See Pattern Programming)
BLACK - Ground
Connections to the 98523 Controller
If you are using the optional 98523 controller (included in some kits), connect the wires as shown below.
• If your kit included the controller, it will also come with two green screw-terminal connectors that can be used to assist in making your connections.
Using the enclosed green connectors, insert the wires into the corresponding terminals shown below, and tighten the screws to secure the wires.
• If you do not have the green connectors, use your own suitable connector(s) or splice the wires together ensuring a good electrical connection.
Connect to optional auxiliary device/light
WHITE w/BROWN: Left Arrow
GREEN w/YELLOW: Right Arrow
ORANGE w/RED: Warn
RED: Power
BLACK: Ground or Battery Negative
RED w/GREEN:
Programming
Note: The Directional functions (Right, Left, and Center-Out)
will override the Warn pattern for the heads that are enabled.
Electrical Connections
Both=Center-Out
20 AMP Fuse
Ignition-Switched Relay
**Standby current < 0.001A
12VDC BATTERY
SHUNT
SHUNT
(See Pattern Programming)
Mounting
Wiring for 4-Head Units
RED - Power
GREEN -
BLACK - Ground
YELLOW
GREEN
BLUE
BROWN
RED
BLACK
12VDC
BATTERY
-2-
1.2"
Pattern Or Phase Select
(See Pattern Programming)
98523 Controller
IGNITION
SWITCHED
RELAY
20 AMP FUSE
Use one of the enclosed shunts
as a jumper between the first two
terminals and use the other shunt
as a jumper between the third and
fourth terminals as shown above.
1.6"
20 AMP
Fuse
12VDC BATTERY
