Idiomas disponibles
Idiomas disponibles
GB
Set the airfl ow speed with a knob. The higher the set value, the higher the airfl ow speed.
Setting the airfl ow temperature
Use the buttons marked with arrows to adjust the temperature. Pressing the arrow up button increases the temperature. Pressing
the arrow down button decreases the temperature. The set temperature will be shown on display. Pressing the button once chang-
es the temperature by 1
O
C. Press and hold the button for faster temperature change.
The station can store three temperature values, which can then be selected with one of the three quick selection buttons marked
CH1, CH2, or CH3. To program the temperature, place the soldering iron in the holder, and set the temperature using the arrow
buttons. Then press and hold one of the quick selection buttons until the memory bank number appears on display. This indicates
that the preset temperature has been stored in this memory bank.
Operation
Depending on the need, install the injector on the nozzle outlet. Place the soldering iron in the holder.
Switch on the station with the power switch. Set the temperature using the arrow buttons or the quick selection buttons.
Grip the soldering iron and point the nozzle outlet towards the workplace. Adjust the airfl ow force using the knob.
Work can be started after the temperature has stabilised, which will be indicated by fl ashing blue light.
After fi nishing work, place the soldering iron in the holder with the nozzle pointing upwards. The device sensor will switch off the
heater and start cooling the soldering iron. When the temperature drops below 100
O
C, the device will switch to standby mode. If
you want to resume operation, lift the soldering iron from the holder, and the device will automatically restore the preset tempera-
ture. If the work will not be resumed, switch off the station with the power switch.
Caution! It is recommended to set the lowest temperature suffi cient for operation and the highest airfl ow speed. Such parameters
allow extending the station and the electronic components service life.
MAINTENANCE AND STORAGE
Allow the soldering iron to cool down, switch off the station with the power switch, and leave it until all elements have cooled down
completely. Disconnect the station from the power supply by pulling the power cord plug out of the power socket. Clean the station
housing and soldering iron holder with a soft cloth slightly dampened with water, then dry it.
Store the product disconnected from the power supply in places not accessible to unauthorised persons, especially children. The
storage place should protect against dust, moisture, precipitation, excessive heat, and provide adequate ventilation to prevent
condensation of water vapour.
O R I G I N A L
I N S T R U C T I O N S
11
