Idiomas disponibles
Idiomas disponibles
ENGLISH
5. CLEANING AND MAINTENANCE
-
The machine must be switched off and disconnected from the mains for cleaning or
maintenance.
-
Do not store the pressure washer outdoors or where it can freeze, the pump could be
severely damaged.
6. TROUBLESHOOTING
Problem
Cause
Smoke comes out of the
Overheating, overloading or
appliance.
motor failure.
There is not enough pressure.
The inlet water filter is
clogged.
Air is entering from the hose
connections to the pump.
The nozzle or discharge valve
is worn or not the correct size.
The pressure washer does
The unit is pressurised.
not turn on.
The plug is not properly
connected or the socket is
defective.
The extension cord is too long
or short.
The supply voltage is too low.
The thermal safety switch has
tripped.
Pressure fluctuates.
The pump is sucking in air.
The nozzle is clogged.
The valves are dirty or worn.
Hydraulic seals are worn.
The motor stops suddenly.
The extension cord is too long
or short.
The thermal safety switch has
tripped due to overheating.
68
HYDROBOOST 1500 EASYMOVE
Solution
Switch off the device
immediately and contact
the Technical Support
Service of Cecotec.
Clean the inlet water filter.
Check that the connections and
the locking ring are tight.
Contact the official Technical
Support Service of Cecotec.
Press the gun trigger.
Check the plug,
the socket and fuses.
Remove the extension cord.
Make sure that the mains
voltage matches the voltage
stated on the rating label of the
appliance.
Switch off the device and allow it
to cool down.
Check that hoses and
connections are tight.
Clean them with the cleaning
clip.
Contact the official Technical
Support Service of Cecotec.
Remove the extension cord.
Make sure that the mains
voltage matches the voltage
stated on the rating label of the
appliance.
7. TECHNICAL SPECIFICATIONS
Product reference: 05717.
Product: Hydroboost 1500 EasyMove.
Power: 1500 W
Voltage: 220-240 V~ 50/60 Hz
Rated pressure: 8 MPa (80 bar).
Max. pressure: 12 MPa (120 bar).
Vibration: ≤ 2,5 m/s2
Nominal flow rate: 6.0 l/min.
Max. flow rate: 7.8 l/min
Weight with the most common configuration: 8 Kg.
5 ºC - 50 ºC IPX5
Made in China | Designed in Spain
8. DISPOSAL OF OLD ELECTRICAL APPLIANCES
The European directive 2012/19/EU on Waste Electrical and Electronic
Equipment (WEEE) specifies that old household electrical appliances must
not be disposed of with the normal unsorted municipal waste. Old
appliances must be collected separately, in order to optimise the recovery
and recycling of the materials they contain and reduce the impact on
human health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation to
dispose of the appliance correctly.
Consumers must contact their local authorities or retailer for information concerning the
correct disposal of old appliances and/or their batteries.
9. TECHNICAL SUPPORT AND WARRANTY
This product is under warranty for 2 years from the date of purchase, as long as the proof
of purchase is submitted, the product is in perfect physical condition, and it has been given
proper use, as explained in this instruction manual.
The warranty will not cover the following situations:
-
The product has been used for purposes other than those intended for it, misused,
beaten, exposed to moisture, immersed in liquid or corrosive substances, as well as any
other fault attributable to the customer.
-
The product has been disassembled, modified, or repaired by persons, not authorised by
the Cecotec official Technical Support Service.
ENGLISH
HYDROBOOST 1500 EASYMOVE
69
