TECNA 9412 Manual De Uso página 9

T O
RANSLATION OF THE RIGINAL
Manual lock
position (G) for routine work conditions.
correct position to allow its release.
ATTENTION: use the locking system ONLY with load hanging;
ATTENTION: if the balancer cable is not fully wound and no load is hanging, DO NOT intervene
and contact the after-sales assistance centre immediately.
(Option 'B': control from below (Fig.2)
Lower the side of the handle with the RED sticker to lock the drum; lower the side of the handle with the GREEN sticker to release it).
OPTION "RI", insulated rotary suspension (Fig.3)
Permits to electrically insulate the load hung on the balancer, e.g. in the case of suspension of welding devices and/or turn the
hanging tool freely without twisting the cable.
ATTENTION: always comply with the safety regulations relative to the electrical equipment.
the split-pin (D) and deform it.
M
AINTENANCE
Maintenance may be carried out only by skilled and authorized personnel.
Use original TECNA S.p.A. spare parts only. When requesting spare parts, the Customer should kindly contact the supplier of the
the supplier or the manufacturer directly.
Never disassemble the balancer. Maintenance is to be carried out only by skilled, authorized
personnel.
W
ARRANTY
The use of non-original TECNA S.p.A. spare parts will negatively affect safety and performance and, in any case, it will void the warranty.
WARNING: The rope and the drum-spring are not covered by warranty.
D
ISPOSAL
- Rewind the rope completely
- Unhook the load from the balancer
- Unhook the balancer from the primary and safety connections.
- Proceed to fully discharge the balancer spring.
Once the balancer has been discharged, it must be disposed of complying with the rules and regulations in force.
I
NSTRUCTIONS
9
[email protected] | ToolBalancersUSA.com | (978) 560-3775
EN