Idiomas disponibles
Idiomas disponibles
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin / bidet.
3. Slip the slide washer, washer and collar nut over
the threaded base and tighten the collar
nut by hand.
4. Tighten screws.
5. Connect the supply pipes to the angle valves;
cold right - hot left.
6. Connect the pull rod to the pop-up waste.
Large differences in pressure between the hot and
cold water supply should be balanced.
Technical Data
This mixer series-produced with
waterdimmer (flow limiter)
Rate of flow with waterdimmer:
Rate of flow without waterdimmer:
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Hansgrohe single hole mixers can be used together
with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
If the continuous flow heater makes any problems or
there comes not enough water, the waterdimmer
(flow limiter 6a) located behind the mousseur must
be removed.
To simplify installation pressure hoses no.
13098000 are available.
English
Spare parts
1
2
3
4
5
6
7
8
8.1 pull knob
8.2 pull rod
9
XXX = Colors
000 chrome plated
090 chrome/gold plated
7 l/min 3 bars
14 l/min 3 bars
max. 10 bars
1 - 5 bars
16 bars
max. 80° C
65° C
knob for cold water
knob for hot water
spout for sink
spout for bidet
washer
mousseur cpl. (10)
ELASTOP stop unit
pull rod cpl.
fixation cpl.
15291XXX
15292XXX
95030XXX
95230XXX
92646000
13085000
94149000
92620XXX
94066XXX
94067000
13961000
