at your choice of intervals during one block of time you set up.
The Video mode is not available in Time Lapse mode.
The Time Lapse default settings are the following:
•
Block of time: 19:00 to 07:00 the next day
•
Time Out: 60 seconds
•
Image resolution: 12M
•
Burst mode: 1 image per trigger
Outside of the Time Lapse time frame, the camera will follow
the user defined PIR settings.
First, you have to set the start and stop times for the time frame
(for example 19:00 to 07:00 the next day). And then you have to
set the interval of time between each still image. The camera
will remain in Time Lapse mode until you change the program
setting.
•
Slide the switch to the SET position from OFF, the status
display will show the camera current status.
•
Press the [M] button once to enter the Manual
programming mode, the word "PIR" or "TLS" will be
blinking.
•
Press the [UP] button until you see
the word "TLS" blinking.
•
Press [OK] to confirm and go into the
Time Lapse Mode "Start Time" setting.
•
The display will show T + S-88:88
(S = Start, 88:88 = time in HH:MM).
•
Press [OK] to set the "Start Time"
setting.
SL1008 - Indice A
59/200