Pfannenberg DTS 6201C Instrucciones De Servicio página 57

GB
3.4.4 DTI cooling unit assembly (installation)
Item Designation
1 Air inlet
3 Device contour
Make cut-outs for the DTI cooling unit
Requirements
- All general requirements have been fulfilled; see
- The unit is de-energized.
Required tools and material
- Saw
- Use a switch cabinet cutter, if applicable
- Protective covers
Procedure
 Use a protective cover to protect the switch cabinet from chips.
 Provide the switch cabinet with cut-outs. For the prescribed dimensions, refer to the figure switch cabinet
exterior view.
 The four corner cut-outs can be rectangular or have a maximum R = 4 mm.
 Deburr the cut edges.
 Remove chips and assembly waste from the switch cabinet.
 Cut-outs have been made.
Operating Manual DTS and DTI 6201C / 6301C Standard Controller (SC) 086100015b © Pfannenberg GmbH
1
3
Figure 12 - Switch cabinet exterior view
DTI cooling unit cut-outs
General assembly requirements
2
Item Designation
2 Air outlet
Page 18 / 39