Out Of Vehicle Battery Test - Tecnotest 3167 Manual Operativo


BATTERY TESTER_________________________________________________________________________
NOTE:
The tester turns on automatically when properly connected to the battery. If it does not
turn on, check the connections. Both clamps must make a solid contact with the
terminals.
6. Continue with the appropriate test steps (in the next three sections).
3.2 -

Out of Vehicle Battery Test

The out of vehicle test takes about 13 seconds to determine if the battery is good, has
a low charge, or is bad. The test shows the battery condition even if the battery is
discharged down to 1 volt state of charge.
To do the out of vehicle test, follow these steps:
1. Do the steps in "Pretest Steps" on chapter 3.1. This displays the main menu on
the tester.
NOTE:
The word GO indicates the selected item.
2. Use the Up and Down Arrow keys to select OUT OF VEHICLE and then press
the GO key. This displays the Choose Battery Type screen.
3. Do one of the following:
If the battery is conventional (flooded lead acid), press the Up arrow key.
If the battery is AGM, press the Down Arrow key.
This displays the battery's open circuit voltage (OCV).
44
OUT OF VEHICLE
IN VEHICLE
QUICK TEST
MULTIMETER
Choose Battery Type
Conventional Batt.
AGM Battery
PRESS 'GO'
GO
12.60V
OPERATING INSTRUCTIONS