Idiomas disponibles
Idiomas disponibles
Starting the Ice Maker
1. IMPORTANT: Make sure freezer lights are on and freezer
door switch remains open when performing this step.
Manually rotate ejector fingers 60 degrees towards a
vertical orientation. To avoid damaging ice maker, ejector
fingers should only be rotated in a clockwise direction (see
illustration).
Before
2. Wash out the ice bucket, and then slide it under the ice maker
(see illustration) as far as it will go. The ice bucket will be
sitting on top of the freezer shelf.
Installing the ice bucket
IMPORTANT: On top-mount models without a full-width
freezer shelf, you will need to place the ice bucket on top of
the inverted ice tray shelf. First, position the ice tray shelf
face down so that the shorter side is alongside the freezer
wall (see DETAIL A). Then insert the tabs on the shorter side
of the shelf into the slots on the edge of the freezer floor. This
will hold the shelf in position. Next, place the ice bucket on
top of the inverted ice tray shelf and slide it under the ice
maker (see illustration). The ice maker will not function
properly if the ice bucket is placed directly on the freezer
floor.
DETAIL A
Tabs
Slots
All manuals and user guides at all-guidesbox.com
3. Place the items back into the freezer compartment.
4. Lower the arm on the ice maker (see illustration) to its "on"
position, and close the freezer door. The ice maker will begin
to make ice within 24 hours.
After
NOTE: It usually takes approximately 24 hours for the ice
maker to begin producing ice. Once ice is available, you may
notice that it has an "off taste." If this happens, make two or
three batches of ice and discard them. After that, the "off-
taste" should be gone. If you have any problems, refer to
"Troubleshooting" section.
This completes the installation of your Ice Maker.
9
Raise arm to stop ice
Off
On
Lower arm to start it
Turning the ice maker on
