Idiomas disponibles
Idiomas disponibles
▶Depress the On/Off switch (5) to start and release it to stop your tool.
▶This tool has a variable speed switch (5) that delivers higher speeds with increased trigger pressure - speed is controlled by varying the
ES
pressure applied to the switch.
3. SWITCH LOCK
▶The switch trigger can be locked in the OFF position. This helps to reduce the possibility of accidental starting when not in use. To lock the
PT
switch trigger, place the direction of rotation control in the center position.
4. FORWARD AND REVERSE ROTATION CONTROL
▶With the drill pointing away from you, push the forward/reverse-lever to the left for forward rotation. Push the forward/ reverse lever to the
EN
right for reverse rotation.
WARNING : Never change the direction of rotation while the tool.
FR
5. FUNCTION MODE SELECTION
▶ The operation of the gearbox for each application is set with the function mode selection switch (4). To change between functions, Squeezed
and rotate the selector to the desired operating mode.
▶For simultaneous drilling and impacting of concrete or masonry, choose the Hammer drilling position. (Fig.1)
▶For drilling into steel, wood and plastics choose the Rotary drilling position. (Fig.2)
WARNING : The operating mode selector switch may be actuated only at a standstill.
6. OVERLOAD PROTECTION
▶When overloaded, the motor comes to a stop. Relieve the load on the machine immediately and allow cooling for approx. 30 seconds at the
highest no-load speed.
7. TEMPERATURE DEPENDENT OVERLOAD PROTECTION
▶When using as intended for, the power tool cannot be subject to overload. When the load is too high or the allowable battery temperature of
70ºC is exceeded, the electronic control switches off the power tool until the temperature is in the optimum temperature range again.
8. BATTERY POWER SHOWING
▶Before the tool work, press the "ON" button to activating battery pack and showing battery electric power.
9. DUST CUP
▶Use the dust cup to prevent dust from falling over the tool and on yourself when performing overhead drilling operations.
▶Attach the dust cup to the bit as shown in the figure.
Instruction manual
Fig.1
ref. 08373
Fig.2
