Create UPWIND SAIL Manual Del Usuario página 11

1. Remove the cotter pin from the clevis pin and pull the clevis pin out.
2. Unscrew the fixing screws.
3. Push the downrod into the top of the motor housing and align the holes on the downrod.
4. Insert the clevis pin back in and lock it with the cotter pin.
5. Fasten the fixing screws.
6. Cover with the motor canopy.
3. Fit two screws to the halfway position on opposite holes until there is approximately 5mm
between the screw head and the rim of the mounting plate. Don't forget to place washers
between the screw head and the mounting bracket.
4. Slide the canopy over the mounting bracket and align the locking slots with the two
screws installed.
5. Twist the canopy and tighten the screws. Install the two remaining mounting screws into
the other two holes on the canopy and tighten firmly.
6. Once the electrical installation has been checked and
completed, push the "ceiling rose" (ceiling trim) up-
wards until the ceiling mount and all the connection
cables are covered. Match the screws by aligning the
holes in the "ceiling rose" (ceiling trim) with the side
holes in the bracket.
7. At this time you can also push the engine canopy down
until it engages with the engine body.
E NGLI SH
11