Create UPWIND SAIL Manual Del Usuario página 10

Downrod installation
Choose the suspension bar that best suits your situation: it has a 15 cm and a 25 cm sus-
pension bar.
Remove the bar bolt, removing the pin, and pass the canopy (roof trim) and the engine
canopy through the suspension bar. Next, route the fan motor cables through the inside of
the suspension bar. Tighten the suspension bar to the engine and insert the bolt and pin.
This fan can be installed both on a normal and a vaulted ceiling, and you can extend the
hanging length using the longer downrod (provided). To install the downrod you will need
the following tools: a screwdriver, a flat-head screwdriver, adjustable pliers or a wrench, a
stepladder, wire cutters and rated electrical tape.
Feed the fan's wires all the way from the motor housing, through the downrod, the decora-
tive cover and canopy to the ceiling.
Tip: Applying a small piece of electrical tape to the ends of the wires will help keep them
together when threading them through the downrod.
Attaching the downrod to the motor housing
Electrical
wiring
Downrod with
hanger ball
Cotter
pin
Adapter
E NGL I SH
10
20° 20°
Ceiling
Canopy
Motor decoration
Clevis
pin
Fixing
screw