Idiomas disponibles
Idiomas disponibles
How to Assemble Your Ceiling Fan
1.
Remove and discard the three rubber/screws motor
stops from the motor assembly. (Figure 1)
2.
Remove the hanger ball portion from the downrod/
hanger ball assembly by loosening the set screw in
the hanger ball until the ball falls freely down the
downrod. Remove the pin from the downrod, then
remove the hanger ball. Retain the pin and hanger
ball for reinstallation in Step 7. (Figure 2)
3.
Remove the hairpin clip and clevis pin from the
bottom of the downrod. Retain the pin and clip for
reinstallation in Step 5. (Figure 3)
4.
Loosen the two set screws and locking nuts in the
downrod support of the motor assembly. Route the
brown, blue, red, gray and yellow wires through the
downrod. (Figure 4)
Motor Stops
Downrod
Hanger Ball
Hairpin Clip
Set Screws and
Locking Nuts (2)
7
Motor
Assembly
Figure 1
Pin
Set Screw
Figure 2
Clevis Pin
Figure 3
Brown, Blue, Red, Gray
and Yellow wires
Downrod
Figure 4
