Idiomas disponibles
Idiomas disponibles
GROUNDING INSTRUCTIONS
For a grounded, cord-connected appliance:
This washer must be grounded. In the event of a malfunction
or breakdown, grounding will reduce the risk of electric shock
by providing a path of least resistance for electric current.
This washer is equipped with a cord having an equipment-
grounding conductor and a grounding plug. The plug must be
plugged into an appropriate outlet that is properly installed
and grounded in accordance with all local codes and
ordinances.
WARNING:
Improper connection of the equipment-
grounding conductor can result in a risk of electric shock.
Check with a qualified electrician or serviceman if you are in
doubt as to whether the appliance is properly grounded.
Do not modify the plug provided with the appliance — If it will
not fit the outlet, have a proper outlet installed by a qualified
electrician.
SAVE THESE INSTRUCTIONS
INSTALLATION INSTRUCTIONS
Unpacking
WARNING
Excessive Weight Hazard
Use two or more people to move and install or uninstall
appliance.
Failure to do so can result in back or other injury.
Before you start: Remove shipping materials.
It is necessary to remove all shipping materials for proper
operation and to avoid excessive noise from washer.
1. Move Washer
Move washer to within 4 ft (1.2 m) of its final location; it must
be in a fully upright position.
NOTE: To avoid floor damage, set washer onto cardboard
before moving it and make sure lid is taped shut.
2. Remove shipping base
IMPORTANT: Removing shipping base is necessary for
proper operation.
To avoid damaging floor, place cardboard supports from
shipping carton on floor behind washer. Tip washer back and
place on cardboard supports. Remove shipping base (some
models require shipping base to be rotated 90° to the right
before pulling off). Set washer upright.
3. Remove packaging material from inside
washer
Remove tape from washer lid, open lid, and remove
packaging material from washer tub. Be sure that all parts
have been removed from inside washer.
NOTE: Keep packaging material for inside washer in case
you need to move washer later.
4. Free power cord
Firmly grasp power cord plug and pull to free from rear panel.
Gently place power cord over console to allow free access to
back of washer.
If the power cord is damaged, it must be replaced by the
manufacturer, by it's service agent authorized, or by qualified
personnel.
7
