Idiomas disponibles
Idiomas disponibles
7
7E
7B
7A
7D
7C
7 HANDLE FLANGE ATTACHMENT
Place Plastic Ring (7A) and Flange (7B) over Valve Body (7C) covering the Valve Body
Washers (7D). Secure by threading Plastic Nut (7E) onto the Valve Body (7C).
8
8C
8D
8A
8B
8 HANDLE INSTALLATION
Screw Stem Extender (8A) onto the Valve Stem (8B). With Valves in "Closed" position,
attach Handle (8C) onto Valve Stems (8B) and tighten Set Screws (8D) with the Hex
Wrench (8E) that is provided.
Make sure Set Screw (8D) is securely tightened to Handle (8C).
7E
7B
7A
7D
7C
8E
8D
8C
8A
8B
ENGLISH
9
9F
9G
9 SPOUT BODY ATTACHMENT
Insert Lift Rod (9A) into hole at the back of Spout (9B). Place Plastic Seal Ring (9C)
against the bottom of Spout Base (9D). Place Spout Base (9D) against the bottom of
Spout Body (9E). With Spout (9F) facing forward, carefully install the Lift Rod (9A) and
Shank (9G) through the center hole of sink (9H).
10
10A
10B
10 SECURING SPOUT BODY
From underneath sink, secure Spout Body (10A) by placing Metal Washer (10B) and
threading Mounting Nut (10C) onto Spout Shank (10D). Make sure that the bumps on
Metal Washer (10B) are facing up. Make sure Lift Rod (10E) moves freely. Be sure
Spout Body (10A) is centered and facing forward and tighten the Mounting Nut (10C)
until Spout Body (10A) is firmly secured to sink.
Caution: Do not over tighten!
3
9E
9D
9C
9A
9H
10D
10E
10C
9A
9B
