Idiomas disponibles
Idiomas disponibles
MAINTENANCE
2. Measure from the floor surface up to the
bottom of the blade tip on the discharge side
of the mower deck. Record the measurement.
3. Move to the opposite side, check that
measurement is the same. If adjustment is
required—with a 3/4" or adjustable wrench,
turn the lift link adjustment nuts on either
side counter clockwise to lower or clockwise
to raise. Adjust until both measurements are
equal.
4. Turn either blade to align with the deck front-
to-rear. If the front blade tip does not measure
1/4" to 3/8" lower than the rear, remove the
foot plate access the front deck adjustment.
With an adjustable wrench, loosen the rear
jam nut on the front suspension linkage.
Make adjustment to level with the front lift link
nut. Clockwise raises the front of the mower,
counter clockwise will lower the front. Adjust
the nut until rear blade tip is 1/4" to 3/8"
higher than the front blade tip.
NOTE: This will position the mower deck in a
standard measurement position. Depending on
the type of grass being mowed or environmental
conditions, additional adjustments may be
required to get the desired cut.
26
Cutting Blades
For the best mowing results, it is important that
blades are correctly sharpened and not damaged.
Replace blades that have been bent or cracked
when hitting obstacles.
Let the service workshop decide if a blade with
large nicks can be repaired/ground or must be
replaced. Balance the blades after sharpening.
Check the blade mounts.
Blade replacement
1. Remove blade bolt by turning counter
clockwise.
2. Install new or resharpened blade with
stamped GRASS SIDE facing towards
ground/grass (down) or THIS SIDE UP facing
deck and cutter housing.
3. Seat the blade's opening firmly onto the cutter
housing.
4. Tighten blade bolt securely.
5. Torque blade bolt to 45-60 ft/lbs (60-81 Nm).
CAUTION! Blades are sharp.
Protect your hands with gloves
and/or wind heavy cloth around the
blades before handling.
The sharpening of blades must
be carried out by an authorized
service workshop.
IMPORTANT INFORMATION Special blade
bolt is heat treated. Replace with a Husqvarna
bolt if required. Do not use lower grade
hardware than specified.
