Installation Limitations
• Do not install your refrigerator in any location not properly
insulated or heated, e.g. garage, etc. Your refrigerator was not
designed to operate in temperature settings below 13℃.
• Select a suitable location for the refrigerator on a hard even
surface away from direct sunlight or heat source, e.g. radiators,
baseboard heaters, cooking appliances, etc. Any floor unevenness
should be corrected with the leveling legs located on the front
bottom corners of the refrigerator.
Door Alignment
Freezer Door: (see fig. #1)
1. Remove the top hinge cover.
2. Loosen the top hinge screws using a phillips head screwdriver.
3. Adjust the door or put a spacer in between and then tighten the
screws.
4. Replace the top hinge cover.
fig. # 1
08
Refrigerator Features And Use General Features
Adjustable temperature dial:
Your refrigerator will automatically maintain the temperature level
you select.
The temperature control dial has 7 settings plus 0. 1 is the warmest.
7 is the coldest. Turning the dial to 0 Stops cooling in both the
refrigeration and freezer sections. At first, set the dial to 4 and allow
24 hours to pass before adjusting the temperature to your needs.
(Note: If the refrigerator has been placed in a horizontal or tilted
position for any period of time wait 3 hours before plugging the unit
in.)
Refrigerator Interior Shelves
To remove or replace a
full-width slide-out shelf:
(see fig. # 2)
1. Gently tilt the shelf up and
slide forward until the shelf has
been completely removed.
2. To replace the shelf, gently
slide the shelf back.
Using the Dispense-A-Can
• Your refrigerator is equipped with the
convenient "Dispense- A-Can" compartment. Each
compartment will hold up to six cans. Simply load
the cans from the top. To dispense a can, simply
draw one out from the bottom. It is that easy.
EN
fig. # 2
fig. # 3
09