Running A Cycle - SciCan HYDRIM M2 G4 Manual Del Operador

5. Instructions for Use (cont.)

5.25 Running a cycle

Before using your HYDRIM, check that the water supply is on and that the HIP™ cleaning
solution bag is correctly installed and attached, then follow these steps:
1
Power unit on.
4. Load instruments into the baskets
4
or cassettes, place them in the
machine and close the door.
7
7. The cycle will begin.
8 8. The cycle is complete.
2 2. Touch the screen to begin.
5
5. Select the desired cycle.
(Use a heavy duty cycle
for cassettes, hinged
instruments or heavily
soiled instruments.)
The cycle will start by draining the unit. The bar on the screen
indicates the progression of the cycle. The stage within the cycle
is shown beneath the bar (e.g. Filling, Rinsing). The estimated time
remaining (in minutes) is always displayed. Please note that the
time will increase or decrease depending on the projected cycle
completion.
When the cycle is complete, the program name and "Cycle
Complete" is displayed, and the unit beeps three times. Press "OK"
to open the door. Use gloves to unload the instruments. After all
cycles, exercise caution as the instruments, trolley, baskets and
cassettes may be hot. Inspect the instruments for debris prior to
packaging / sterilizing.
26
3. Press UNLOCK if required.
3
6 6. Press START.