Husqvarna LC 151S Manual De Usuario página 13

Note:
To increase the performance in side discharge
mode, install the mulch plug. (Fig. 32)
To empty the grass catcher
CAUTION:
you move it to prevent wear.
1. Lift the grass catcher with the frame handle.
2. Use the frame handle and the bag handle when you
empty the grass catcher. (Fig. 35)
To get a good result
• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not
a service agent, speak to them for information about the
nearest service agent.
For more detailed information, refer to
www.husqvarna.com.
Maintenance
Do a general inspection
Examine the oil level
Replace the oil (the first time after 5 h of use, then after each 50 h of
1
use)
Clean the product
Examine the cutting equipment
Examine the cutting cover *
Examine the engine brake handle *
Examine the muffler *
Examine the spark plug. Clean or replace the spark plug if it is
necessary
1
If the product is operated with heavy load or in high ambient temperatures, replace the engine oil each 25
hours.
1924 - 002 - 12.10.2022
Lift the grass catcher when
Maintenance
Before you do
• Do not cut more than ⅓ of the length of the grass.
Use the highest cutting height when you start to cut
the grass. Examine the result and lower the cutting
height to an applicable level. If the grass is very long,
operate slowly and cut 2 times if it is necessary.
• Cut in different directions each time to prevent
stripes in the lawn.
• Lift the rear cover and remove the grass catcher.
• If a mulch plug and a mulch blade are attached,
remove them.
• Close the rear cover before you operate the product.
When you operate the product, the cut grass
discharges below the rear cover.
• Keep the cutting cover clean. Buildup from grass
and dirt on the inner side of the cutting cover can
decrease the cutting result. Refer to
inner surface of the cutting cover on page 14 .
Maintenance schedule
CAUTION:
is up and not against the ground when you
tilt the product. Risk of engine damage.
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * refer to instructions in
Safety devices on the product on page 9 .
Daily
X
X
X
X
X
X
To clean the
Make sure that the air filter
Monthly Each season
X
X
X
13