Troubleshooting - Husky HD1500 HSDS Manual Del Usuario

PROBLEM OR CONCERN
Detergent is not dispensing Detergent suction tube has been
disconnected or clogged.
Detergent to Water ratio
Detergent - What to use
Circuit breaker trips or Fuse Circuit overload
blown in Fuse Box
Extension cord too long or wire
size too small
Nozzle partially blocked
Excessive pressure
GFCI Plug installation
GFCI Plug malfunction
Gun/Hose - Leaking water
Leaking Oil from Pump A small amount of leakage is
normal
Leaking water from bottom Machine Inlet connection is de-
of unit fective
English

8.0 TROUBLESHOOTING

POSSIBLE CAUSE
18
SOLUTION
Remove the soap lance assembly from the de-
tergent bottle. Make sure that the clear tube is
properly connected to the soap lance. If it is not
connected then reconnect it.
Your Powerwasher draws detergent at a 10:1
ratio. Most pressure washer detergents are gene-
rally concentrated within that range so minimal
adjustment is required. If you feel like you are
using more detergent than is required for the ap-
plication you can dilute it with regular tap water.
We recommend that you use a cleaner which is
specifically designed for power washers. There
are different kinds available depending on the
application. Check with your local Home Depot
store for the product which is best suited for
your needs.
Never use Bleach, Ammonia or Hot
water in the unit.
Check that the circuit is rated at 15 amps or
greater. Make sure the unit is plugged into a
dedicated circuit.
Use proper extension cord as recommended in
owner's manual.
Clean Nozzle as instructed in section 6.2.
Clean Nozzle as instructed in section 6.2
For GFCI reset procedures see owner's manual
section 4.3. For instructions regarding the GFCI
Plug installation or malfunction please email us
directly at customerservice@huskypowe
rwasher.com.
Gun/Hose will need to be replaced. Replace-
ment parts are not available for the Gun/Hose.
Email us at customerservice@huskypow
erwasher.com for assistance or order onli-
ne at www.huskypowerwasher.com.
If leakage occurs please contact us directly at custo
[email protected].
Check the Machine Inlet at the back of the unit to
ensure that water is not leaking from it. If the con-
nection is leaking it will have to be replaced.
Contact us at customerservice@huskypow
erwasher.com or order a replacement directly
online at www.huskypowerwasher.com.