Operating Instructions; Start-Up Procedure; Variable Spray Nozzle - Husky HD1500 HSDS Manual Del Usuario

5.0

OPERATING INSTRUCTIONS

WARNING: Risk of Injury. Do not
direct discharge stream at anyone.
WARNING
5.1

START-UP PROCEDURE

1. Make sure water supply is connected and turned
on. (Do not use hot water).
2. Make sure the unit is plugged in.
3. Release gun safety if locked. (Fig. 17) Shown on
page 11.
4. Remove any dirt or foreign matter from the gun
outlet and the male connector of the wand.
5. Insert the wand into the gun's quick connect coupling
by pushing firmly and twisting wand ¼ of a turn to
lock into place. (Fig. 13) Shown on page 10.
6. To allow air to escape from the hose, squeeze
trigger on the gun until there is a steady stream of
water coming from the nozzle.
Fig. 18
English
WARNING: If the wand is not securely
locked into place, it could be ejected
under high pressure when operating
WARNING
the gun.
7. Press power switch on the pressure washer to the
"ON" position. (Fig.18)
8. Squeeze the gun trigger to start the pressure
washer.
WARNING: Make sure the wand is
pointed in a safe direction when starting
the pressure washer. Do not point at face
WARNING
or feet as serious injury could result.
NOTE: Make sure wand is locked. (see fig.13) As
shown on page 10.
5.2

VARIABLE SPRAY NOZZLE

The variable spray nozzle can adjust spray from fan
to pencil point. The spray is adjusted by turning the
nozzle. (Fig.19-20)
Fig. 19
Fig. 20
14
Fig. 21