REMOTE CONTROL OPERATING PROCEDURES:
(1) Power:
Turn the unit ON and OFF.
NOTE: When the unit is turned off that the logs and flames will slowly die down.
(2) Brightness:
Adjust the
flame and log
brightness level: L5 - L4 - L3 - L2 - L1
(L5 being the brightest and L1 the dimmest)
: raise the level of flame and log brightness.
: lower the level of flame and log brightness.
(3) Heater:
This allows programming of the thermostat. The fireplace can be used without the heater if desired.
Note: ℉ for the default units
Adjust the temperature as follows: 99℉(60℃)→ 86℉(30℃)→ 82℉(28℃)→78℉(26℃) → 75℉(24℃)→ 71℉(22℃) →OFF
: raise the temperature rating,
: lower the temperature rating.
(4) Down Light:
Turn the down light ON and OFF.
(5) Timer:
Timer setting switch: 10min- 20min- 30min- 40min- 50min- 1H- 2H- 3H- 4H- 5H- 6H- 7H- 8H- 9H.
DO NOT operate fireplace while unattended.
(6) Effect:
Dynamic Ember: This function will make the ember of the fire automatically glow dimmer and brighter creating a more
realistic fire effect.
Note:
Do not mix old and new batteries.
Do not mix alkaline, standard(carbon-Zinc)or rechargeable(nickel-cadium)batteries.
The heater will turn on when temperature is set higher than the room's temperature and it will automatically
turn off when the room has reached the desired temperature.
14 |
(1)
(2)
(5)
Self Regulating Heater
(4)
(3)
(6)
