MPM MZP-01 Manual De Instrucciones página 21

DESCRIPTION OF DEVICE
1. Housing
2. Steam heel
3. Power switch
4. Operating mode light
5. Steam on/off button with lock
6. Water tank release buttons
Thick fabric brush (9) — for better steam penetration, ideal for thick fabrics, such as coats.
Fabric brush (10) — instantly collects threads, hair, flocs or animal hair from delicate materi-
als, such as velour, velvet or wool.
Automatic continuous steam jet (36 g/min).
BEFORE FIRST USE
1. Take out the device from the box and remove all protective cardboard elements and foil.
2. Unwind and straighten the cable before use.
NOTICE SMOKE MAY COME OUT OF device DURING FIRST USE. THIS SHALL STOP AFTER
SHORT WHILE.
PREPARING FOR USE
FILLING WATER TANK
1. Make sure the device is unplugged from mains.
2. Press the two buttons (6) to release water tank, remove water tank (7).
3. Open the water tank inlet cover (7a).
4. Fill the tank with water to the maximum level. Check the water level by putting the tank in an
upright position.
NOTICE! Do not fill the tank above MAX line. For best results and to prevent scaling, use fresh
demineralised or distilled water. Do not use decalcified water produced using chemical methods
nor any other liquids.
5. Close the water tank inlet cover (7a).
6. Insert the water tank back into the device.
ATTACHING ACCESSORIES
1. To attach brushes, unplug the device from mains and wait for the device to cool down.
2. Firmly hold the device with one hand, and use the other hand to attach the brush so the notches
in the brush align with grooves in the device's working section, you will hear a click when the brush
locks. To remove a brush, hold the device and pull handle in the bottom part of the attachment.
NOTICE! Always unplug the steamer before attaching or removing a brush attachment. Be care-
ful — steam heel may still be hot!
The brushes improve steam penetration of thick and heavy fabrics thus ensuring better
results. The brush attachments are designed for use with steam.
7. 250 ml water tank with scale
7a. Water tank inlet cover
2. Rotary power supply cable (2.5 m)
3. Thick fabric brush
4. Delicate fabric brush
EN
21