About This Guide
This installation guide provides basic
instructions for installing the DWL-3610AP Unified
AC Selectable Dual-band PoE Access Point on
your network. For additional information about
how to use the Access Point, please see the User
Manual, which is available on the CD included in
this package or from the D-Link support website.
System Requirements
- CD-ROM Drive
- Windows
, Macintosh
®
operating system
- Ethernet port or installed Ethernet adapter
- Internet Explorer 7.0, Safari 5.0, Firefox 4.0,
or higher
Unpacking the Product
Open the shipping carton and carefully unpack its
contents. Please consult the packing list located
in following information to make sure all items are
present and undamaged. If any item is missing
or damaged, please contact your local D-Link
reseller for replacement.
- DWL-3610AP Unified AC Selectable Dual-band
PoE Access Point
- Power Adapter*
- Mounting Ring
- Console Cable*
- CD-ROM
- Ceiling Bracket (3 sets, sizes are 9/16", 14/16",
and 1 1/2")
*The power adapter is an optional accessory and not
included in the package in some regions. To power
the units use a D-Link PoE switch or the D-Link
DPE-101GI PoE injector.
*The console cable is an optional accessory and
not included in the package in Armenia, Azerbaijan,
Belarus, Georgia, Israel, Kaliningrad, Kazakhstan,
Kyrgyzstan, Latvia, Lithuania, Moldova, Mongolia,
Russia, Turkey, Turkmenistan, Ukraine, and
Uzbekistan. If a cable is required, please contact your
reseller to order it (Model: ACS-AP-CONSOLE).
2 D-Link DWL-3610AP Quick Install Guide
2 D-Link DWL-3610AP Quick Install Guide
, or Linux-based
®
Optional Accessories
- PoE Base Unit (Model: DPE-101GI)
Note: These accessories are not included in
the package. If any of these items are required,
please contact your reseller to order it.
Hardware Overview
LEDs
Figure 1. DWL-3610AP LEDs
WLAN – When the LED is lit up, the access
point's radio is enabled. It will blink
when there is wireless traffic. When
the LED color is Amber, it is working
on 2.4GHz. When the color is Green, it
is working on 5GHz.
LAN – When this LED is lit up, the device's
Ethernet port is connected to an active
router or switch. The light will blink
when there is traffic going through the
port.
POWER – When the LED is lit up, the access
point is powered and ready for use.
Interfaces
Console Port
LAN Port (PoE)
Figure 2. DWL-3610AP Rear Panel
LAN
Power Receptor
