Idiomas disponibles
Idiomas disponibles
POTENTIAL HAZARD
Grass clippings and other objects can be
thrown from an open discharge tunnel.
WHAT CAN HAPPEN
Thrown objects can cause serious injury or
kill operator or bystanders.
HOW TO AVOID THE HAZARD
Never start or operate the mower unless
one of the following is true:
1.
The discharge tunnel plug is locked
securely in discharge tunnel.
2.
The grass bag is locked in place.
3.
The optional side discharge chute is
locked in place.
4.
The discharge tunnel door is locked
closed.
Underside of Mower Housing
Keep underside of mower housing clean. Be
especially careful to keep kickers free of debris
(Fig. 30).
Washing Method
After every use, follow this procedure for washing
debris out from the underside of the mower housing.
1.
Position mower on a flat surface near a garden
hose.
2.
Start the engine.
3.
Engage the blade.
4.
Hold the running garden hose at handle level and
direct water to flow on ground just in front of
right rear tire (Fig. 29). The rotating blade will
draw water under the housing and wash out
clippings. Let the water run for a few minutes or
until you no longer see clippings being washed
out from under housing.
EN–15
All manuals and user guides at all-guides.com
5.
6.
7.
Scraping Method
If washing does not remove all debris from under
deck, tip mower and scrape it clean.
1.
2.
3.
4.
5.
6.
7.
Belt Cover
Keep area under belt cover free of debris.
1.
Cleaning Blade Brake Clutch
Shield
The BBC (Blade Brake Clutch) shield should be
cleaned periodically during the mowing season and at
the end of each mowing season to ensure best
performance and to prevents parts degradation. It is
convenient to clean the BBC shield at the same time
the blade is being sharpened because the blade needs
to be removed in order to remove the BBC shield.
Disengage the blade.
Turn off the garden hose.
Restart mower and let it run for a few minutes to
dry out moisture on the mower and its
components. While the engine is running,
engage and disengage the safety system and
traction drive several times to dry them out.
Pull wire off spark plug. Remove key from
switch on electric start models.
Drain gasoline from fuel tank: refer to Draining
Gasoline, page 11.
Tip mower on its right side (Fig. 30).
Remove dirt and grass clippings with a
hardwood scraper. Avoid burrs and sharp edges.
Turn mower upright.
Refill gas tank.
Reconnect spark plug wire.
Remove bolts securing belt cover (Fig. 27) to
mower housing. Lift off cover and brush out all
debris from belt area. Reinstall belt cover.
