Idiomas disponibles
Idiomas disponibles
In order to use the appliance the two feet supplied must be
fitted to the same by operating as follows:
-
Always unplug the appliance before you assemble.
-
Put the appliance down horizontally on a flat, smooth
surface.
-
Position the feet by inserting the hook into the slot on
the side and make it run until the lower hooks block
Model HC0001 with hooks.
Wall installation
1)
Warning: the feet not must be assembled.
2)
With wall installation, the wall to which the appliance
is secured must be made of masonry and/or of heat-
resistant material (not wood, or synthetic material
which can easily overheat); also, follow these
indications for the installation:
3)
The appliance must be positioned so that the
bottom side is away from the floor at least 400mm.
4)
The upper grill is perfectly horizontal (see fig.1), at a
distance of at least
-
300 mm from the corners of walls
-
600 mm from the corners of walls
- 1000 mm from flammable materials (curtains, fabrics, etc.).
5) The appliance not be near socket outlets.
6) First drill the holes is good to measure the distance of the above holes.
7) Higher part: fix two hooks to the wall at a distance of 510mm apart, make the holes on the
wall, inserting the hooks into the slots provided with screws.
8) Inferior part: fix two hooks on the bottom of the metal body, fig.3 Hang the appliance on
the wall by inserting the hooks into the slots provided in the rear panel. Mark the exact
positioning of the holes on the bottom of the metal bracket to the wall at a distance of
660mm apart; remove the appliance, make the holes on the wall, inserting the slots
provided. Re-hang the convector heater on the wall and fix the bracket use the screws to
secure the appliance to the wall.
Fig.1
17
